Turbine shafts, marine drive shafts and gearbox shafts forged from ingots we control end to end. Each shaft is forged with the grain flow following the service load, heat treated to the drawing, then ultrasonically tested over the full length before the mechanical properties are taken.
Parts we forge
- Rudder Stock & Pintle Forgings
- Hydro Turbine Shaft Forgings
- Turbine Main Shaft Forgings
- Gearbox Shaft Forgings
- Wind Turbine Main Shaft Forgings
- Pump Shaft & Valve Stem Forgings
- Marine Shaft Forgings | Crankshaft, Propeller & Intermediate
Send the drawing with the finished weight, the material specification and the testing level. We quote the ingot route, the forging ratio, the heat treatment cycle and the non-destructive testing schedule — then certify the part, not a separately melted test bar.
