Heavy forging is where a supplier is separated from a stockholder: the part is made to a drawing, not picked from a shelf. We forge shafts, rotors, rolls, rings, pressure vessel components and die blocks from ingots we control the melting route for, then test and certificate each piece against the drawing rather than against a catalogue.
What we forge
Shaft forgings (7)
Turbine, marine and gearbox shafts up to the largest ingot we can forge.
- Rudder Stock & Pintle Forgings
- Hydro Turbine Shaft Forgings
- Turbine Main Shaft Forgings
- Gearbox Shaft Forgings
- Wind Turbine Main Shaft Forgings
- Pump Shaft & Valve Stem Forgings
- Marine Shaft Forgings | Crankshaft, Propeller & Intermediate
Rotors and discs (6)
Generator and turbine rotors, compressor discs, retaining rings.
- Turbine & Compressor Disc Forgings
- HP & IP Turbine Rotor Forgings
- Generator Rotor Forgings
- Retaining Ring Forgings
- LP Turbine Rotor Forgings
- Turbine Disc & Wheel Forgings
Mill rolls (4)
Back-up, intermediate and work rolls for hot and cold strip mills.
- Back-up Roll Forgings
- Intermediate Roll Forgings
- Leveller & Skin-Pass Roll Forgings
- Cold Mill Work Roll Forgings
Ring and flange forgings (4)
Seamless rings, nuclear flanges, wind turbine flanges.
- Nuclear Flange Ring Forgings
- Slewing Ring Forgings
- Wind Turbine Flange Forgings
- Large Seamless Ring Forgings
Pressure vessel forgings (6)
Reactor, hydroprocessing and tubesheet forgings, including duplex and low temperature grades.
- Duplex Stainless Forgings
- Low-Temperature Forgings
- RPV Forgings
- Hydroprocessing Reactor Forgings
- Large Forged Flanges
- Heat Exchanger Tubesheet Forgings
Blocks and heavy parts (5)
Die blocks, press columns, cylinders, crossbeams and shells.
- Forged Die Blocks
- Press Cylinder Forgings
- Press Column Forgings
- Heavy Press Crossbeam Forgings
- Pressure Shell Forgings
How the order is quoted
Send the drawing, the finished weight, the material specification and the testing level. We come back with the ingot route, the forging ratio, the heat treatment cycle and the non-destructive testing schedule — ultrasonic to the severity you name, magnetic particle or dye penetrant on machined surfaces. Mechanical properties are taken from a sacrificial extension, not from a separately melted test bar, so the certificate describes the part you receive.
Marking, machining allowance and delivery condition (as forged, normalised, quenched and tempered, or rough machined) are agreed per order.
































